// Controllers · PlanetCNC
CAM for PlanetCNC
Machines run by PlanetCNC TNG with Mk3 or Mk4 controllers.
From another CAM post
What the PlanetCNC post writes
- % at the start and end; G90 G94 G17 G91.1
- T<n> M6 then G43 H<n> (tool table)
- Drilling cycles G81 / G82 / G83 with G98 (chip breaking as moves)
- Rigid tapping G33.1 Z K (spindle encoder needed)
- Dwell in seconds
Files end in .ngc. Every file is read back before export and checked against the simulated toolpath.
Shaped after Autodesk's Fusion PlanetCNC post (2026).
Where this post comes from
- Another CAM program: Autodesk Fusion PlanetCNC post (2026)
Not yet confirmed on a machine. This post follows the sources above. Before the first real job, run the controller check in the air, or compare with a file that already runs on your machine (Export options → Check this post).