CAM for Syntec

Machining centres with Syntec milling controls (SYIL and many others).

From the maker's documents

Open MillPath The controller check

What the Syntec post writes

G71 for millimetres and G70 for inches (Syntec words)
% and O1000, G91 G28 Z0 before every T<n> M6, G0 G43 Z<clearance> H<n>
Drilling cycles with G98, rigid tapping M29 + G84, dwell P in milliseconds
Cutter compensation G41 / G42 D<n> for wear

Files end in .nc. Every file is read back before export and checked against the simulated toolpath.

Shaped after Autodesk's Fusion SYIL post (2026), the Fanuc-style dialect with Syntec's unit words.

Where this post comes from

The controller maker: SYNTEC Mill Machine Program Manual (G70 / G71 units, G04 / G82 dwell)
Another CAM program: Autodesk Fusion SYIL (Syntec) post (2026)

Not yet confirmed on a machine. This post follows the sources above. Before the first real job, run the controller check in the air, or compare with a file that already runs on your machine (Export options → Check this post).