// Controllers · UCCNC
CAM for UCCNC
Machines run by CNCdrive UCCNC (STEPCRAFT and many routers).
From another CAM post
What the UCCNC post writes
- T<n> M6: UCCNC's M6 macro does the change (manual or tool changer); no G43
- Dwell G4 P and G82 P in milliseconds
- Drilling cycles G81 / G82 / G83 / G73 with G98, rigid tapping G33.1
- Arcs up to 90 degrees, helical arcs
Files end in .nc. Every file is read back before export and checked against the simulated toolpath.
Shaped after Autodesk's Fusion STEPCRAFT UCCNC post (2026).
Where this post comes from
- Another CAM program: Autodesk Fusion STEPCRAFT UCCNC post (2026)
Not yet confirmed on a machine. This post follows the sources above. Before the first real job, run the controller check in the air, or compare with a file that already runs on your machine (Export options → Check this post).